|
After removing I discarded the air filter and air box (pic 6) now you will need to remove the MAF (mass air flow sensor)(pic 7) cause you’ll need to put it on the new CAI (be sure to be careful removing the sensor because it may be stuck in place) now install the MAF on the new housing(pic 8) pay attention to what type of screws were holding the sensor in place(some are machine screws and others are self taping screws) Pic 9 shows the MAF installed.
Now install the CAI body to the throttle body. Note; installation was a little difficult to get on because the silicone gasket was very tight (pic 10)
|