Lone Star Stangs | The Texas Mustang Club - View Single Post - KOOKS long tube headers install

Jay Tee · 10-27-2006, 05:15 PM

Now that the header in its now home the O2 sensor will not reach (pic82) will have to A) buy an extension or B) cut and splice it (pic83 and 84)

Now that that’s done and the driver side is installed (the drivers side was a little bet ezer to do its done the same way as the passenger side.i did one side first then the other)
I put the cats and the X pipe together on the driveway first then I installed to the headers
(pic86)leave the pipes lose so the you can adjust em and line em up with rest of the exhusest system then tighten all down starting from the collectors working your way down (pic 87) this took me about 10 hours to do this over a 3 day span ..
now I load my tune … I will post video of how it sounds with open cat headers and with the JBA axel backs.

10-27-2006, 05:15 PM	#11
Jay Tee Registered User Join Date: Oct 2006 Location: in the city Posts: 73 Trader Rating: (0)	Now that the header in its now home the O2 sensor will not reach (pic82) will have to A) buy an extension or B) cut and splice it (pic83 and 84) Now that that’s done and the driver side is installed (the drivers side was a little bet ezer to do its done the same way as the passenger side.i did one side first then the other) I put the cats and the X pipe together on the driveway first then I installed to the headers (pic86)leave the pipes lose so the you can adjust em and line em up with rest of the exhusest system then tighten all down starting from the collectors working your way down (pic 87) this took me about 10 hours to do this over a 3 day span .. now I load my tune … I will post video of how it sounds with open cat headers and with the JBA axel backs. Attached Thumbnails Last edited by Jay Tee; 10-27-2006 at 05:31 PM.