View Single Post
Old 02-01-2008, 10:46 PM   #22
Bigdrumma22
Evil Angel
 
Bigdrumma22's Avatar
 
Join Date: Apr 2007
Location: San Antonio, TX
Posts: 1,228

Trader Rating: (5)
Send a message via AIM to Bigdrumma22 Send a message via Yahoo to Bigdrumma22
Wink

Hopefully by now you have this figured out, but like everyone else has pretty much said, buying the correct wiring harness is the easiest route. I had this same problem when installing a stereo in my friends Tiburon. Everything was working but sound... then when I went over all the wires I realized I had left the amp turn on wire disconnected. His car had factory amps but all the other cars I had done installs on previously didn't, so I was used to not connecting that wire unless it had an aftermarket amp like mine do. Needless to say after about 20 min. troubleshooting, as soon as I got that wire connected, the fat lady sang! It's very easy to overlook simple things like that if you're not careful. Just words of advice speaking from experience. Hope you got it all figured out!
__________________

2002 Mustang GT, 271hp/306tq on 87 CMR Tune, Roush short throw rally style shifter, King Cobra Clutch, Roush CAI, C&L Plenum, BBK/Roush 75mm T/B, Kooks L/Ts w/catted X, Bassani Cat-back, Eibach Pro-kit Springs, Energy Suspension bushings, KYB AGX's, Hotchkis C/C plates, UPR ProStreet rear control arms, Brembo Drilled/Hawk pads, BFG's, Dual Halo Projector 8k HIDs, Kenwood: KDC-X790, KAC-9102D, KAC-8402; Infinity: 6810CS, 6812CF; Orion: P series subs all powered by Optima
My car http://www.cardomain.com/ride/2628572
My truck http://www.cardomain.com/ride/2206751
Bigdrumma22 is offline   Reply With Quote