5.0 Parts For Sale

Allnuts · 09-18-2007, 08:43 PM

Ram 10.5 clutch kit for 87-93 mustang-$40

Factory Tailpipes from '98 Cobra-$25

Factory Upper & Lower intake for 87-93 Mustang-$20

Rubber Valve Cover Gasket for 302-$15

Oil Pan for 302-$25

Factory Driveshaft from T-5 setup-$30

Factory Thermostat Housing from 302-$10

Spider for lifters from 302-$10

AOD (needs to be rebuilt) from '91 Mustang-$100

Craftsman Buffer-$10

Everything is to be pick up or shipped. These prices don't include shipping.

**thesource** · 09-18-2007, 08:47 PM

I'll take the block plate for the T5 if you are going to be around the south east side or the north east side anytime soon .

stangrod2000 · 09-19-2007, 02:04 AM

Ill take the tailpipes. PM sent.

bad302 · 09-19-2007, 11:25 AM

ill take the gt tailpipes,t5 trans shield, and the craftsman buffer.
check pm and call and will buy and pickup today. thanks.

09-18-2007, 08:43 PM	#1
Allnuts LoneStarStangs Addict Join Date: Jun 2003 Location: San Antonio,Tx Posts: 704 Trader Rating: (-1)	5.0 Parts For Sale Ram 10.5 clutch kit for 87-93 mustang-$40 Factory Tailpipes from '98 Cobra-$25 Factory Upper & Lower intake for 87-93 Mustang-$20 Rubber Valve Cover Gasket for 302-$15 Oil Pan for 302-$25 Factory Driveshaft from T-5 setup-$30 Factory Thermostat Housing from 302-$10 Spider for lifters from 302-$10 AOD (needs to be rebuilt) from '91 Mustang-$100 Craftsman Buffer-$10 Everything is to be pick up or shipped. These prices don't include shipping. Last edited by Allnuts; 10-25-2007 at 06:54 PM.

09-19-2007, 02:04 AM	#3
stangrod2000 Registered User Join Date: Feb 2007 Location: san antonio, tx Posts: 45 Trader Rating: (0)	Ill take the tailpipes. PM sent. __________________ 1991 GT: only mods are h-pipe with gutted cats and 1 chamber flows with dumps.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

09-18-2007, 08:47 PM	#2
thesource LSS Sponsor Join Date: Nov 2004 Location: in a hole building transmissions Posts: 3,102 Trader Rating: (12)	I'll take the block plate for the T5 if you are going to be around the south east side or the north east side anytime soon .

09-19-2007, 11:25 AM	#4
bad302 Registered User Join Date: Aug 2005 Location: San Antonio,Texas Posts: 107 Trader Rating: (0)	ill take the gt tailpipes,t5 trans shield, and the craftsman buffer. check pm and call and will buy and pickup today. thanks.