07-11-2008, 11:28 PM
|
#1 |
|
Registered User
|
Changing Fog Lights
A couple of weeks ago I went to used parts place and bought a new left front inner wheel well for my 03 Mach. It had torn in half. I also bought new fog lights as well as mine were starting to dim. Anyway, I go back home, jacked up the front and I couldn't take out the fog light. I got kind of frustrated so I just replaced the well and abandoned the light project. The fog lights were too far in and had some bolts that were impossible to get out. Any ideas on how to do this install without taking off the front bumper?
|
|
|
|
07-13-2008, 10:27 PM
|
#2 | |
|
Don't hate!
 
|
No need to remove the bumper to get to them. It takes a little time, but all can be done from under neath. Ratchet wrench will work best, unless you happen to have wobble sockets and some extensions.
__________________
Quote:
Built 00 Windsor engine, .20 over, 11.6:1cr, fully ported heads, Hardballer intake w/cooling mod, Scat rods, Probe pistons, Cobra crank, tri-metal Clevite race bearings, VT Stage 2 N/A cams, adjustable cam gears, Canton windage tray, MMR oil pump, Cobra pick up, 75MM Accufab t-body, Dragon plenum, JLT CAI, 24# injectors, Bassani mid lengths, mufflers & O/R X,255lph fuel pump, BBK FPR, Fidanza aluminum flywheel, AJE K-member, ARP hardware everywhere, X-Cal SCT custom tuned, 3.73's, Pro 5.0, polygraphite motor mounts. |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
