Egr Do it yourself MIL Eliminator

[sicksn95]

This is a quick and safe way to get rid of your egr warning light, when you run your car without the egr valve.

Disconnect your EGR wire harness

You will need to go to radio shack and purchase 3 resistor's, 2- 3.9k ohm 1/2 watt resistor's and 1- 390 ohm 1/2 watt resistor.

Use the attached diagram, and solder the resistors as shown.

[sicksn95]

this should be a sticky

[HISS]

You can also buy 4 spark plug anti foulers, in 18mm, drill two with a 1/2 in bit, install the undrilled ones in the bungs. Then screw the drilled ones in to the first set of foulers, install downstream o2's and viola cheap o2 sims.