05-22-2008, 08:08 PM
|
#1 |
|
Registered User
|
runs bad
well lets see, my 01 GT was running fine a few days ago. i start it up after it has been sitting for a few days, and it barely wants to start. when driving it misses, acts like it wants to die at idle. and runs horrible. the car has been tuned with the turbo setup, and it has been running fine all up until yesterday. the car has a code p0602 which control module prog. error. any advice sure help out/
|
|
|
|
05-22-2008, 09:11 PM
|
#3 | |
|
Don't hate!
 
|
P0602 is a communication problem with a handheld or possibly a chip error.
__________________
Quote:
Built 00 Windsor engine, .20 over, 11.6:1cr, fully ported heads, Hardballer intake w/cooling mod, Scat rods, Probe pistons, Cobra crank, tri-metal Clevite race bearings, VT Stage 2 N/A cams, adjustable cam gears, Canton windage tray, MMR oil pump, Cobra pick up, 75MM Accufab t-body, Dragon plenum, JLT CAI, 24# injectors, Bassani mid lengths, mufflers & O/R X,255lph fuel pump, BBK FPR, Fidanza aluminum flywheel, AJE K-member, ARP hardware everywhere, X-Cal SCT custom tuned, 3.73's, Pro 5.0, polygraphite motor mounts. |
|
|
|
|
|
05-24-2008, 10:59 AM
|
#5 | |
|
Don't hate!
|
How long ago was it modded, who tuned it, how long has it acted up, is it all the time, is it intermittent??
__________________
Quote:
Built 00 Windsor engine, .20 over, 11.6:1cr, fully ported heads, Hardballer intake w/cooling mod, Scat rods, Probe pistons, Cobra crank, tri-metal Clevite race bearings, VT Stage 2 N/A cams, adjustable cam gears, Canton windage tray, MMR oil pump, Cobra pick up, 75MM Accufab t-body, Dragon plenum, JLT CAI, 24# injectors, Bassani mid lengths, mufflers & O/R X,255lph fuel pump, BBK FPR, Fidanza aluminum flywheel, AJE K-member, ARP hardware everywhere, X-Cal SCT custom tuned, 3.73's, Pro 5.0, polygraphite motor mounts. |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
